necking

基本解釋

Molly is necking with Ted and thinking of Ken.
莫莉和泰德親熱的時候還想著肯。
WIND: Typically, this results from your diet and lifestyle – overdoing the fruit and fibre, gobbling your food too fast, necking fizzy drinks and chewing gum or pen tops.
腸胃氣脹：通常，這是由飲食和生活方式引起的——食用了過多的水果和纖維、吃東西過快、喝了太多汽水、嚼口香糖或啃筆帽。
Few drinkers might want to be seen in public necking such downmarket stuff, but in the privacy of their own homes, who can tell the difference, especially after five or six?
恐怕沒有飲酒者愿意在公共場合被看見自己鐘情于低端市場，但是對于他們自己家中的隱私，特別是五點或六點鐘后，誰敢說各家的情況有所不同呢？

Do you think I should neck or not? I shall not enter the kingdom of heaven anyway so I don't see what difference it makes.'" And then she writes back, Mary Brittle: "Dear Sabbath: Light necking is acceptable, but I think your real problem is one of adjustment to the modern world.
你認為我是該做還是不該做，我反正都上不了天堂了,因此，我認為做不做都無所謂，之后她給她回信了，瑪麗-巴瑞特，親愛的薩巴斯，你的做法是可接受的，但我認為,你真正的問題是無法融入現代社會。
耶魯公開課 - 1945年后的美國小說課程節選

They say, even when a teenager says in counseling, I'm thinking about necking with my boyfriend, what do you think?
NPR: Slate's Jurisprudence: Kansas Sex Ban Challenged
We had clear enough evidence about a month and a half ago that allowed us to start necking down to the point we were able to prosecute the action last night against that safe house.
NPR: Attack on Zarqawi Followed Weeks of Waiting

頸縮
The expansion motion, necking instability and the process of fragmentation are analyzed for M-state TU1 and L04 rings, and the simulation of expanding tube’s tensile-shear fracture was also carried out.
以M態TU1環和LO4環為例,分析了金屬環的運動、頸縮形成與碎裂過程,并對膨脹筒拉剪斷裂進行了數值模擬。
縮口
The analysis result indicated that, with the increase of semi-cone angle of cavity die, the limit necking coefficient augment.
通過分析可知:隨著凹模半錐角的增大,管材極限縮口系數也隨之增大。
縮頸

頸縮
During the forming process, when the ratio of thickness in neighboring regions of a deforming sheet metal drops below the critical magnitude RC,necking develops.
在薄板成形過程中,當板面內的厚度梯度值小于臨界厚度梯度值RC時,認為薄板發生頸縮。
內退刀槽
收口切頸
頸縮加工
縮口
壓肩